przejście do zawartości
ItBrain
Narzędzia użytkownika
Zaloguj
Narzędzia witryny
Szukaj
Narzędzia
Pokaż stronę
Poprzednie wersje
Odnośniki
Ostatnie zmiany
Menadżer multimediów
Indeks
Zaloguj
>
Ostatnie zmiany
Menadżer multimediów
Indeks
Ślad:
security
Ta strona jest tylko do odczytu. Możesz wyświetlić źródła tej strony ale nie możesz ich zmienić.
*Wyłączenie SeLinux*\\ <code> vi /etc/sysconfig/selinux # This file controls the state of SELinux on the system. # SELINUX= can take one of these three values: # enforcing - SELinux security policy is enforced. # permissive - SELinux prints warnings instead of enforcing. # disabled - SELinux is fully disabled. SELINUX=disabled </code> tymczasowo\\ <code> echo 0 >/selinux/enforce </code> włączenie <code> Re-Enabling SELinux If you've disabled SELinux as in the section above, and you want to enable it again then you've got a bit of work to do. The problem will be that files created or changed when SELinux was disabled won't have the correct file labels on them - if you just reboot in enforcing mode then a lot of stuff won't work properly. What you need to do is to enable SELinux by editing /etc/selinux/config (for Fedora/RedHat) or by adding selinux=1 to the kernel boot line, then boot into permissive mode, then relabel everything, and then reboot into (or simply switch to) enforcing mode. After booting into permissive mode, run fixfiles relabel Alternatively, in Fedora and RedHat Enterprise Linux you can run touch /.autorelabel and reboot or put autorelabel on the boot command line - in both cases the file system gets a full relabel early in the boot process. Note that this can take quite some time for systems with a large number of files. </code>
security.txt
· ostatnio zmienione: 2017/01/25 08:03 przez
jpiechnik
Narzędzia strony
Pokaż stronę
Poprzednie wersje
Odnośniki
Do góry